Panda 12000x-230V PMS

General Technical Data

Model.:Panda 12000x-230V PMS
Generator TypeGeneratoren mit fester Drehzahl (3000 UpM 50 Hz)
    Generator Family12000x-230V
      Generator Version.:PMS
        Article number.:0000169 ( <2017 :
        Additional Features
          Area of Application.:Marine Generator (M)
          Frequency [Hz]50
          Generator manufacturerFischer Panda GmbH
          Isolation class of windingsH
          Nominal Speed [rpm]3000
          Voltage RegulationxControl
          Power rating factor Cos Pi0.85
          Excitation byMKP Capacitors

          Electrical Alternator

          Single Phase Winding - Standard version

          Alternator TypeHP1
          Nominal Voltage in Volt230
          Power rating factor Cos Pi0.85
          Nominal Performance in kW1)10.20
          Nominal Performance in kVA1)12.0
          Continuous Performance in kW1)9.1
          Continuous Performance in kVA1)10.8
          Number of Phases1
          Frequency [Hz] 50

          1) up to Panda 15000 / 12-4 cosPhi 0,85 for short take-off power to inductive loads, otherwise cosPhi1
          1) from Panda 18 /17-4 on cosPhi 0,85 optional startup performance with compensation or starting current boost, otherwise cosPhi1

          All performance data applies to generator operation at 100m above sea level at 20°C. Performance reductions can occur when operating at greater heights.

          Engine Data

          Engine ManufacturerKubota (KU)
          Engine TypeD722
          No. Cylinders3
          Displacement [cm3]719
          Starter System12V (24V Optional)

          Sound Insulation Cover (Generator Housing / Sound Shield)


          VersionGFK 3D
          Article Number0000169
          =< 2016 (
          CAD REF:0013208
          Drawing Ref.FP1-044837
          Sound Cover TypeGFK (Glass fibre reinforced polyester)
          Sound Insulation Material3D
          Dimensions Housing    L x W x H *) *)) Refer to Capsule Drawing of Sound Shield
          Total Weight of Generator with Capsule Refer to Capsule Drawing of Sound Shield
          Sound Cover Upgrade Options (on request)->MPL 4DS


          All technical data and specifications including dimensions, performance data, weight and material specifications are only valid when they are explicitly expressed in writing. All data should be considered only for approximation purposes because the data from these sources is gathered from current and previous models. As a result of continual product improvement and modification, the validity of technical data from these sources cannot be guaranteed. 3D-models are only provided on special request. It is the responsibility of the customer to ensure in all cases when ordering that technical data is valid and that the specifications meet his/her requirements.

          *) The dimensions are for the sound insulation housing ONLY and do not include additional parts or fittings such as fasteners, closures or mounting brackets etc.

          Therefore please note: You must consider the additional space will need to be calculated for the installation. This is of importance when planning the installation with respect of cables, hoses and mounting feet.

          **) Generators with DVS windings are slightly longer than those with HP1 or HP3 windings. Specific dimensions are available on request.

          Service- / installation kits and shock mountings

          Note: Actual Service- / installation kits and shock mountings may differ from those displayed depending on Generator type.

          Service kit

          Service Kit "PLus"

          Installation Kit Basic (without exhaust/water separator)

          Installation kit Premium (with exhaust/water separator)

          Shock-mounting, captive

          Shock-mounting, non-captive