Motion 6.000 PMS

General Technical Data

Model.:	Motion 6.000 PMS
Generator Type	Direct Current (DC) Motion
Generator Version	6.000 external 12V fuel pump
Generator Version.:	PMS Easy to install Suitable for internal installation Low ambient temperatures External control panel with cable incl. Seawater impeller pump incl. Freshwater (coolant) pump Heat Exchanger for Engine and Winding (dual circuit cooling)
Additional Features	12V/10A Alternator for charging the starter battery
Area of Application.:	Marine Generator (M)
Frequency [Hz]	400
Generator manufacturer	Fischer Panda GmbH
Isolation class of windings	H
Winding Type	Permanent Magnet
Charging Voltage	Direct

Electrical Alternator

Engine Speed [rpm]	2400 - 3000
Nominal Performance ³⁾⁴⁾⁵⁾	06.00
Continuous Performance [kW] ⁴⁾⁵⁾	On request
Nominal Voltage [V] ³⁾	On request
Constant current rate [A]	Current dependent upon voltage
Peak current rate [A]	Current dependent upon voltage

Engine Data

Engine Manufacturer	Kubota (KU)
Engine Type	Z482
No. Cylinders	2
Bore and Displacement [cm³]	479
Starter System	12V (24V Optional)

Sound Insulation Cover (Generator Housing / Sound Shield)

Fischer Panda Generator Capsule Drawing REF:FP1-019610_preview.jpg

Version	GFK 3D
Sound Cover Type	GFK (Glass fibre reinforced polyester)

Sound Insulation Material	3D
Dimensions Housing L x W x H ^*)	Refer to Capsule Drawing of Sound Shield
Total Weight of Generator with Capsule	Refer to Capsule Drawing of Sound Shield
Sound Cover Upgrade Options (on request)	->MPL 4DS

Disclaimer

All technical data and specifications including dimensions, performance data, weight and material specifications are only valid when they are explicitly expressed in writing. All data should be considered only for approximation purposes because the data from these sources is gathered from current and previous models. As a result of continual product improvement and modification, the validity of technical data from these sources cannot be guaranteed. 3D-models are only provided on special request. It is the responsibility of the customer to ensure in all cases when ordering that technical data is valid and that the specifications meet his/her requirements.

*) The dimensions are for the sound insulation housing ONLY and do not include additional parts or fittings such as fasteners, closures or mounting brackets etc.
Therefore please note: You must consider the additional space will need to be calculated for the installation. This is of importance when planning the installation with respect of cables, hoses and mounting feet.

Downloads


	Capsule / Sound shield Drawing:FP1-019610.pdf

	Additional information:Marine_Generator_eng_R11.pdf
	Additional information:Installation & Service Guide 2011_Buch_eng_deu.R01.pdf