Motion 6.000 PMS

Print Preview as Datasheet

General Technical Data

Model.:Motion 6.000 PMS
Generator TypeDirect Current (DC) Motion
    Generator Family6.000
    • external 12V fuel pump
    Generator Version.:PMS
    • Suitable for internal installation
    • Low ambient temperatures
    • External control panel with cable
    • incl. Seawater impeller pump
    • incl. Freshwater (coolant) pump
    • Heat Exchanger for Engine and Winding (dual circuit cooling)
    Additional Features
    • 12V/10A Alternator for charging the starter battery
    Area of Application.:Marine Generator (M)
    Frequency [Hz]400
    Generator manufacturerFischer Panda GmbH
    Isolation class of windingsH
    Winding TypePermanent Magnet
    Charging VoltageDirect

    Electrical Alternator

    Engine Speed [rpm]2400 - 3000
    Nominal Performance 1)06.00
    Continuous Performance [kW] 1)On request
    Nominal Voltage [V] 1)On request
    Constant current rate [A]Current dependent upon voltage
    Peak current rate [A]Current dependent upon voltage
     

    All performance data applies to generator operation at 100m above sea level at 20°C. Performance reductions can occur when operating at greater heights.

    Engine Data

    Engine ManufacturerKubota (KU)
    Engine TypeZ482
    No. Cylinders2
    Displacement [cm3]479
    Starter System12V (24V Optional)

    Sound Insulation Cover (Generator Housing / Sound Shield)

     

    VersionGFK 3D
    Sound Cover TypeGFK (Glass fibre reinforced polyester)
     
    Sound Insulation Material3D
    Dimensions Housing    L x W x H *) *)) Request - Please contact us
    Total Weight of Generator with Capsule Request - Please contact us
    Sound Cover Upgrade Options (on request)->MPL 4DS

    Disclaimer

    All technical data and specifications including dimensions, performance data, weight and material specifications are only valid when they are explicitly expressed in writing. All data should be considered only for approximation purposes because the data from these sources is gathered from current and previous models. As a result of continual product improvement and modification, the validity of technical data from these sources cannot be guaranteed. 3D-models are only provided on special request. It is the responsibility of the customer to ensure in all cases when ordering that technical data is valid and that the specifications meet his/her requirements.

    *) The dimensions are for the sound insulation housing ONLY and do not include additional parts or fittings such as fasteners, closures or mounting brackets etc.

    Therefore please note: You must consider the additional space will need to be calculated for the installation. This is of importance when planning the installation with respect of cables, hoses and mounting feet.

    **) Generators with DVS windings are slightly longer than those with HP1 or HP3 windings. Specific dimensions are available on request.

    Service-/installation kits and shock mountings